Dear OpenMC community!
I have a very general question
(its in the end related to my previous post (problem-with-openmc-meshsurfacefilter-openmc) but this didnt get much feedback).
How does one debug OpenMC when the regular means run out (i.e. increasing verbosity or running in debug mode)?
Today I ran into a similar issue then above with a simulation the uses openmc.MeshFilter.
The simulations just hangs on batch 28 forever (the point where this occurs changes with the seed used - but doesn’t help furher)
Is it not recommended to use Meshes at all?
Any leads I could follow?
Best
Richard